Jonathan, This should sort that out:
conf t config-register 0x2102 end copy run start ! or wr mem sh boot remote command switch sh boot In my experience, if the RP shows the correct confreg value, and the SP doesn't, a "wr mem" on the RP usually writes the correct value to the SP. cheers, Dale On Wed, Apr 23, 2008 at 1:36 PM, Jonathan Charles <[EMAIL PROTECTED]> wrote: > AMLIATLCORE#remote command switch sh boot > > BOOT variable = bootdisk:s3223-ipbase_wan-mz.122-18.SXF8.bin,12; > > CONFIG_FILE variable does not exist > BOOTLDR variable does not exist > Configuration register is 0x2100 > > AMLIATLCORE# > > That may be it, how do we change it??? > > > > Jonathan > > On Tue, Apr 22, 2008 at 10:24 PM, Dale Shaw <[EMAIL PROTECTED]> wrote: > > What does "remote command switch sh boot" say the config-register is? > > > > Is it possible the SP is set to boot to ROMMON, but the RP isn't? > > (seems unlikely, since if the RP is 0x2102, a "wr m"/"copy run start" > > would sort out the SP confreg value) > > > > cheers, > > Dale > > > > On Wed, Apr 23, 2008 at 12:52 PM, Jonathan Charles <[EMAIL PROTECTED]> > wrote: > > > We just deployed a 6513E with a Sup720. > > > > > > It is running IOS, but when it reboots it goes straight into rommon > > > and you need to type boot to get it to load... once you do that it > > > boots fine... > > > > > > My worry is that this site has power issues... > > > > > > Here is some output: _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/