R1#show ip route vrf priv
Routing Table: priv
Gateway of last resort is 209.212.66.1 to network 0.0.0.0
209.212.64.0/29 is subnetted, 1 subnets
C 209.212.64.176 is directly connected, GigabitEthernet0/1.1000
S* 0.0.0.0/0 [1/0] via 209.212.66.1, GigabitEthernet0/1.1000
ip route 209.212.64.177 255.255.255.255 GigabitEthernet0/1.1000
209.212.64.177
ip route vrf priv 0.0.0.0 0.0.0.0 GigabitEthernet0/1.1000 209.212.66.1
global
interface GigabitEthernet0/1.1000
description << Priv VRF for MON T1/DSL >>
encapsulation dot1Q 1000
ip vrf forwarding priv
ip address 209.212.64.177 255.255.255.248
no ip redirects
no cdp enable
So for now I just want the vrf priv to route to the Internet via another
router. There's two routers in 209.212.64.176/29. The other one has
similar config except it's 209.212.64.178.
Right now a ping drops exactly half the packets:
R1#ping vrf priv 209.212.66.1
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 209.212.66.1, timeout is 2 seconds:
!.!.!
Success rate is 60 percent (3/5), round-trip min/avg/max = 1/2/4 ms
I will eventually add certain T1/DSL interfaces to the VRF priv in order
to "move" them behind a traffic shaping device so diagnostics can be
performed.
-Jason
[EMAIL PROTECTED] wrote:
What about the return path? What did you do to get traffic back into the VRF?
Also, what do you mean it does not work as the next hop? Did the static route not appear
in the routing table after you added it? Can you give us some config output/"show
ip route vrf" output?
---- Jason Berenson <[EMAIL PROTECTED]> wrote:
Oliver,
I tried that but it doesn't seem to work. The IP that exists in the
global routing table (just an interface on the router) is not pingable
from within the VRF. It also does not work as a next hop.
-Jason
Oliver Boehmer (oboehmer) wrote:
Jason Berenson <> wrote on Monday, July 14, 2008 7:37 AM:
Greetings,
I know how to route leak between VRFs with BGP but is it possible to
set a default route within a VRF pointing to an IP in the global
routing table? If so can anyone point me to some good documentation
or perhaps a sample snippit?
ip route vrf FOO 0.0.0.0 0.0.0.0 <next-hop> global
the next-hop must not be a local address of the PE..
oli
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
