I think you need two additional commands: bridge irb - to enable integrated routing and bridging bridge 1 route ip - to enable routing of IP from routed network to bridged.
Regards Nigel > Hi > For the redundancy/failover sake I'm bridging 2 Q-in-Q interfaces. > Here is config: > > interface BVI1 > ip address 10.67.201.100 255.255.255.0 > > interface GigabitEthernet0/2.4012010 > encapsulation dot1Q 401 second-dot1q 2010 > no cdp enable > bridge-group 1 > > interface GigabitEthernet0/3.4012010 > encapsulation dot1Q 401 second-dot1q 2010 > no cdp enable > bridge-group 1 > > interface BVI1 > ip address 255.255.255.0 > > bridge 1 protocol ieees > > Network looks like this: > > Router==QinQ==(MAN Switches Ring)----LanSwitch---Host(10.67.201.5) > > Router physically connected to 2 core switches and terminates dot.Q > tunnels. > MAN switches carry vlan tunnels and the when the LAN enters into > the MAN Ring it is assigned outer tag 401. > The Host is inside LAN on VLAN 2010 and connected through access > port. The ip 10.67.201.100 is going to be default GW for the LAN > Host and must remain reachable even if one of the core switches > goes down. When I assign IP address to either G0/2.4012010 or > G0/3.4012010 sub interfaces I'm able to ping it from the Host. But > after bridging them I can't ping BVI1 from the Host. What am I > doing wrong? Is it supposed to work this way? > > Regards, Victor _______________________________________________ cisco-nsp mailing list [email protected] https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/
