Hi - I'm struggling to get PBR working on a 2811, wonder if someone can
show me with where I'm being special.
The 2811 has two connections coming in on ATM0/2/0 (binding to Di1) and
ATM0/3/0 (binding to Di0). I've got a small gaggle of VLANs. I'm trying
to get VLAN10 sending/receiving everything over Di1 and everything else
over Di0.
If I do ip route 0.0.0.0 0.0.0.0 Dialer0, everything goes over Di0, as
expected. If I cancel that and change it to ip route 0.0.0.0 0.0.0.0
Dialer1, then everything goes via that. So, I know that my connections
are good. It's something internal I'm not getting right.
So, to start setting this up - everything is currently running over
Dialer0. ATM0/2/0 is up over Di1, but there's no route for it.
VLAN10 is 192.168.10.0/24, so creating an access list as per this:
ip access-list extended Network10
permit tcp any 192.168.10.0 0.0.0.255
permit tcp 192.168.10.0 0.0.0.255 any
Then...
route-map PBR_Network10 permit 10
match ip address Network10
set interface Dialer1
interface Fa0/0.10
description Network10Uplink
ip policy route-map PBR_Network10
ip route 0.0.0.0 0.0.0.0 Dialer1 10
As I understand it, this should work - however, from the outside, trying
to ping the address of Di1 results in no replies. Also, VLAN10 can't
route over the connection, instead still routing over Di0.
What am I doing wrong?
Thanks!
Gary
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
