Router# sh int t6/1 transceiver ITU Channel not available (Wavelength not available), Transceiver is internally calibrated. If device is externally calibrated, only calibrated values are printed. ++ : high alarm, + : high warning, - : low warning, -- : low alarm. NA or N/A: not applicable, Tx: transmit, Rx: receive. mA: milliamperes, dBm: decibels (milliwatts).
Optical Optical Temperature Voltage Current Tx Power Rx Power Port (Celsius) (Volts) (mA) (dBm) (dBm) ---------- ----------- ------- -------- -------- -------- Te6/1 25.2 0.00 0.0 N/A N/A On Jun 10, 2011, at 3:27 PM, Mandeep Singh wrote: > > Hi, > Is there a similar command on the 6500s as on the Junipers below: > > show interfaces diagnostics optics xe-0/0/8 > Physical interface: xe-0/0/8 > Laser bias current : 39.304 mA > Laser output power : 0.7050 mW / -1.52 dBm > Module temperature : 41 degrees C / 106 degrees F > Module voltage : 3.2490 V > Receiver signal average optical power : 0.1063 mW / -9.73 dBm > Thanks. > -Mandeep > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/