Pre-configuration is possible with XR as well adam
-----Original Message----- From: cisco-nsp-boun...@puck.nether.net [mailto:cisco-nsp-boun...@puck.nether.net] On Behalf Of Daniel Roesen Sent: Wednesday, December 28, 2011 1:15 PM To: cisco-nsp@puck.nether.net Subject: Re: [c-nsp] How to see interface configuration after card failure on ASR9K On Wed, Dec 28, 2011 at 10:31:31AM +0800, Mark Tinka wrote: > On Wednesday, December 28, 2011 03:13:35 AM John Neiberger > wrote: > > > I thought for sure there was a command that would show > > the preconfigured interfaces. As soon as I insert the > > new card, the preexisting configuration will magically > > appear again. > > That is the Juniper way :-). No, with JUNOS adding/removing hardware won't change the config at all. You can preconfigure interfaces that were never installed in the chassis before, and config remains present when shutting down or even removing interfaces. Looks like IOS-XR still has a long way to go to become as usable as JUNOS in "configuration" matters. Best regards, Daniel -- CLUE-RIPE -- Jabber: d...@cluenet.de -- dr@IRCnet -- PGP: 0xA85C8AA0 _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/