Try to set the load-interval to 30s, then check again. Thanks and regards, Xu Hu
On 8 Aug, 2012, at 21:54, "Aaron" <aar...@gvtc.com> wrote: > anybody know why me3600 svi doesn't seem to show in and out bit counts that > the underlying phy int shows? ....all svi's (10,11,13) are in a vrf running > over mpls l3vpn > > > > > > 3600#sh int vl 10 | in 30 sec > > 30 second input rate 2000 bits/sec, 3 packets/sec > > 30 second output rate 1000 bits/sec, 3 packets/sec > > > > 3600#sh int g0/1 | in 30 sec > > 30 second input rate 402000 bits/sec, 359 packets/sec > > 30 second output rate 6157000 bits/sec, 613 packets/sec > > > > > > Details. > > > > 3600>sh ver | in IOS > > Cisco IOS Software, ME360x Software (ME360x-UNIVERSAL-M), Version 15.2(2)S, > RELEASE SOFTWARE (fc1) > > > > 3600>sh spann in g0/1 > > > > Vlan Role Sts Cost Prio.Nbr Type > > ------------------- ---- --- --------- -------- > -------------------------------- > > VLAN0010 Desg FWD 4 128.1 P2p > > VLAN0011 Desg FWD 4 128.1 P2p > > VLAN0012 Desg FWD 4 128.1 P2p > > VLAN0013 Desg FWD 4 128.1 P2p > > > > 3600>sh int g0/1 | in 30 sec > > 30 second input rate 545000 bits/sec, 459 packets/sec > > 30 second output rate 14636000 bits/sec, 1318 packets/sec > > > > 3600>sh int vla 10 | in 30 sec > > 30 second input rate 2000 bits/sec, 4 packets/sec > > 30 second output rate 2000 bits/sec, 4 packets/sec > > > > 3600>sh int vla 11 | in 30 sec > > 30 second input rate 0 bits/sec, 0 packets/sec > > 30 second output rate 0 bits/sec, 0 packets/sec > > > > 3600>sh int vla 12 | in 30 sec > > ^ > > % Invalid input detected at '^' marker. > > > > 3600>sh int vla 13 | in 30 sec > > 30 second input rate 0 bits/sec, 0 packets/sec > > 30 second output rate 0 bits/sec, 0 packets/sec > > > > 3600>sh spann vl 12 > > > > VLAN0012 > > Spanning tree enabled protocol rstp > > Root ID Priority 24588 > > Address f47f.3549.dd80 > > This bridge is the root > > Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec > > > > Bridge ID Priority 24588 (priority 24576 sys-id-ext 12) > > Address f47f.3549.dd80 > > Hello Time 2 sec Max Age 20 sec Forward Delay 15 sec > > Aging Time 300 > > > > Interface Role Sts Cost Prio.Nbr Type > > ------------------- ---- --- --------- -------- > -------------------------------- > > Gi0/1 Desg FWD 4 128.1 P2p > > > > > > > > _______________________________________________ > cisco-nsp mailing list cisco-nsp@puck.nether.net > https://puck.nether.net/mailman/listinfo/cisco-nsp > archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/