Would be great if multicast worked corrected through the efp.
On 8/9/2012 10:19 AM, Aaron wrote:
Thanks Reuben. By efp's, I take it you mean the command structure for
Ethernet service instance, bride domain, etc. right ?
Aaron
-----Original Message-----
From: Reuben Farrelly [mailto:reuben-cisco-...@reub.net]
Sent: Wednesday, August 08, 2012 3:51 PM
To: Aaron
Cc: cisco-nsp@puck.nether.net
Subject: Re: [c-nsp] me3600 svi's not showing in and out bit counts that i
see on corresponding phy int
It seems to be an architecture thing - this has been the case across all of
the code drops on this platform so far to date. I suspect only process
switched data is counted in those interfaces.
You'll need to poll EFP's on these switches instead of VLAN interfaces for
measuring data flows - those are per-service+per-port and the SNMP counters
on those do get populated. And if you're not yet using EFP's then you're
probably not using these switches to their full potential :-)
Reuben
On 8/08/2012 11:54 PM, Aaron wrote:
anybody know why me3600 svi doesn't seem to show in and out bit counts
that the underlying phy int shows? ....all svi's (10,11,13) are in a
vrf running over mpls l3vpn
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
_______________________________________________
cisco-nsp mailing list cisco-nsp@puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/