Hello, I have created a l2pt between sw1-gi0/1 and sw2-gi0/1 so both switches are logical connected. The te1/1 interface has the lowest cost so gi0/1 in sw2 goes in BLK state. When the connection between sw4 and the isp swich goes down, the link between sw2 and sw4 stays up but no bpdu's are received. gi0/1 in sw then goes in FWD state. So when the link between sw4 and isp comes up you have loop till some bpdu is received on sw2 gi0/1.
How can i prevent this interface going in fwd state? What am i missing? Kind regards Erik gi0/1 do1q gi0/1 access vlan 170 vlan23 mode dot1q-tun, l2pt stp +-----------------+ +-----------+ | sw1 root br +--------------> sw3 | | | | | +-+---------------+ +-----+-----+ | te1/1 vlan 23 | | | | | trunk dot1q vlan 170 | | | +--------v---------+ | | isp l2 network | non cisco | +--------^---------+ | | | | | | | | trunk dot1q vlan 170 | | |te1/1 vlan23 | +-v----------------+ +------+----+ | sw2 |X |sw4 | | +------------> | +------------------+ +-----------+ gi0/1 dot1q gi0/1 access vlan 170 vlan 23 mode dot1q-tun, l2pt stp _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/