Bad SPA or bad SIP. Try moving the SPA to a different slot in the SIP. If it comes up that could point to the original slot as faulty. If it doesn't help it could be a bad SPA.
- Ed On Apr 22, 2015, at 07:27, Jordi Magrané Roig <jordimagr...@hotmail.com> wrote: Dear colleagues, I have an ASR1006 with ESP20, RP2 and two SIP10. Recently I have inserted one SPA 1x10G into one of the SIP10 and I have seen the following log messages: Apr 22 12:00:53: %IOSXE_OIR-6-INSSPA: SPA inserted in subslot 1/2 Apr 22 12:01:00: %LINK-3-UPDOWN: SIP1/2: Interface EOBC1/1, changed state to up ASR1006-LIS01-02#sh ip int Apr 22 12:01:03: %IOSXE_SPA-6-UPDOWN: Interface TenGigabitEthernet1/2/0, link down due to local fault Apr 22 12:01:03: %SPA_OIR-6-ONLINECARD: SPA (SPA-1X10GE-L-V2) online in subslot 1/2 Apr 22 12:01:11: %IOSXE_SIP_SPA-4-SPABUS: SIP1/2: Subslot 2, Read SPA BUS access failed. timeout=0 err=1 par=0 err_c=0x10883 addr=0x00045008 data =0x0 ASR1006-LIS01-02# Apr 22 12:01:12: %IOSXE_SIP_SPA-3-DEVICE_ERROR: SIP1/2: subSlot 2, spatype 0x50C. Device error: critical fault occured ASR1006-LIS01-02# Apr 22 12:01:15: %CMCC-3-PLIM_STATUS: SIP1: cmcc: A PLIM driver informational error RXSPI2 Out of Frame, block 15 count 3 ASR1006-LIS01-02# Apr 22 12:01:17: %SPA_OIR-3-RECOVERY_RELOAD: subslot 1/2: Attempting recovery by reloading SPA ASR1006-LIS01-02# ASR1006-LIS01-02# Apr 22 12:01:17: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# Apr 22 12:01:26: %IOSXE_SIP_SPA-3-SPI4_NOTSYNC: SIP1/2: SPA-1X10GE-L-V2[1/2]: Can not synchronize SPI4 bus (host: src in sync, sink not in sync, spa: src in sync, sink not in sync). ASR1006-LIS01-02# Apr 22 12:01:31: %SPA_OIR-3-RECOVERY_RELOAD: subslot 1/2: Attempting recovery by reloading SPA ASR1006-LIS01-02# Apr 22 12:01:31: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# Apr 22 12:01:39: %IOSXE_SIP_SPA-3-SPI4_NOTSYNC: SIP1/2: SPA-1X10GE-L-V2[1/2]: Can not synchronize SPI4 bus (host: src in sync, sink not in sync, spa: src in sync, sink not in sync). ASR1006-LIS01-02# Apr 22 12:01:44: %SPA_OIR-3-RECOVERY_RELOAD: subslot 1/2: Attempting recovery by reloading SPA ASR1006-LIS01-02# Apr 22 12:01:44: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# Apr 22 12:01:52: %IOSXE_SIP_SPA-3-SPI4_NOTSYNC: SIP1/2: SPA-1X10GE-L-V2[1/2]: Can not synchronize SPI4 bus (host: src in sync, sink not in sync, spa: src in sync, sink not in sync). ASR1006-LIS01-02# Apr 22 12:01:57: %SPA_OIR-3-RECOVERY_RELOAD: subslot 1/2: Attempting recovery by reloading SPA ASR1006-LIS01-02# Apr 22 12:01:57: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# ASR1006-LIS01-02# Apr 22 12:02:05: %IOSXE_SIP_SPA-3-SPI4_NOTSYNC: SIP1/2: SPA-1X10GE-L-V2[1/2]: Can not synchronize SPI4 bus (host: src in sync, sink not in sync, spa: src in sync, sink not in sync). ASR1006-LIS01-02# Apr 22 12:02:10: %SPA_OIR-3-RECOVERY_RELOAD: subslot 1/2: Attempting recovery by reloading SPA ASR1006-LIS01-02# Apr 22 12:02:10: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# Apr 22 12:02:18: %SPA_OIR-3-SPA_POWERED_OFF: subslot 1/2: SPA 1x10GE XFP SPA powered off after 5 failures within 1200 seconds ASR1006-LIS01-02# Apr 22 12:02:18: %SPA_OIR-6-OFFLINECARD: SPA (SPA-1X10GE-L-V2) offline in subslot 1/2 ASR1006-LIS01-02# Apr 22 12:02:18: %IOSXE_SIP_SPA-3-SPI4_NOTSYNC: SIP1/2: SPA-1X10GE-L-V2[1/2]: Can not synchronize SPI4 bus (host: src in sync, sink not in sync, spa: src in sync, sink not in sync). ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# ASR1006-LIS01-02# Apr 22 12:02:47: %IOSXE_OIR-6-REMSPA: SPA removed from subslot 1/2, interfaces disabled Any ideas about this issue? ASR1006-LIS01-02#sh platform Chassis type: ASR1006 Slot Type State Insert time (ago) --------- ------------------- --------------------- ----------------- 0 ASR1000-SIP10 ok 13w5d 0/0 SPA-5X1GE-V2 ok 13w5d 0/1 SPA-4XOC3-POS ok 13w5d 0/2 SPA-1XOC12-POS ok 13w5d 0/3 SPA-4XOC3-POS ok 13w5d 1 ASR1000-SIP10 ok 13w5d 1/0 SPA-5X1GE-V2 ok 13w5d 1/1 SPA-4XOC3-POS ok 13w5d 1/2 SPA-1X10GE-L-V2 booting 00:00:01 1/3 SPA-4XOC12-POS ok 13w5d R0 ASR1000-RP2 ok, active 13w5d R1 ASR1000-RP2 ok, standby 13w5d F0 ASR1000-ESP20 ok, active 13w5d F1 ASR1000-ESP20 ok, standby 13w5d P0 ASR1006-PWR-AC ok 13w5d P1 ASR1006-PWR-AC ok 13w5d Slot CPLD Version Firmware Version --------- ------------------- --------------------------------------- 0 09111601 12.2(33r)XNC 1 09111601 12.2(33r)XNC R0 10021901 12.2(33r)XND R1 10021901 12.2(33r)XND F0 08041102 12.2(33r)XNC F1 08041102 12.2(33r)XNC ASR1006-LIS01-02# ASR1006-LIS01-02#sh ver Cisco IOS Software, IOS-XE Software (X86_64_LINUX_IOSD-ADVIPSERVICESK9-M), Version 15.2(4)S6, RELEASE SOFTWARE (fc4) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2014 by Cisco Systems, Inc. Compiled Thu 14-Aug-14 19:30 by mcpre IOS XE Version: 03.07.06.S Cisco IOS-XE software, Copyright (c) 2005-2014 by cisco Systems, Inc. All rights reserved. Certain components of Cisco IOS-XE software are licensed under the GNU General Public License ("GPL") Version 2.0. The software code licensed under GPL Version 2.0 is free software that comes with ABSOLUTELY NO WARRANTY. You can redistribute and/or modify such GPL code under the terms of GPL Version 2.0. For more details, see the documentation or "License Notice" file accompanying the IOS-XE software, or the applicable URL provided on the flyer accompanying the IOS-XE software. ROM: IOS-XE ROMMON ASR1006-LIS01-02 uptime is 13 weeks, 5 days, 11 hours, 5 minutes Uptime for this control processor is 13 weeks, 5 days, 11 hours, 6 minutes System returned to ROM by reload at 00:18:14 CET Fri Jan 16 2015 System restarted at 00:21:28 CET Fri Jan 16 2015 System image file is "bootflash:asr1000rp2-advipservicesk9.03.07.06.S.152-4.S6.bin" Last reload reason: Reload Command This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable to comply with U.S. and local laws, return this product immediately. A summary of U.S. laws governing Cisco cryptographic products may be found at: http://www.cisco.com/wwl/export/crypto/tool/stqrg.html If you require further assistance please contact us by sending email to exp...@cisco.com. cisco ASR1006 (RP2) processor with 4238183K/6147K bytes of memory. Processor board ID FOX1608H96D 10 Gigabit Ethernet interfaces 17 Packet over SONET interfaces 32768K bytes of non-volatile configuration memory. 8388608K bytes of physical memory. 1826815K bytes of eUSB flash at bootflash:. 78085207K bytes of SATA hard disk at harddisk:. Configuration register is 0x2102 Thanks in advance for your support. Best regards, Jordi _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/ _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/