Hi,
Thank you for your response. So, the set up is this:
Site 1:
MX3600X-24CX-M - Running 15.4(3)S2
BFD: Session Host: Hardware - session negotiated with platform adjusted
timer values.
interface GigabitEthernet0/7
no switchport
mtu 9216
ip address 10.0.16.13 255.255.255.252
ip ospf dead-interval minimal hello-multiplier 3
ip ospf 1 area 0
speed nonegotiate
mpls ip
bfd interval 50 min_rx 50 multiplier 5
end
Site 2:
ASR-920-24SZ-M - Running 03.16.03a.S
BFD Session Host: Hardware - session negotiated with platform adjusted
timer values.
interface GigabitEthernet0/0/2
mtu 9216
bandwidth 1000000
ip address 10.0.16.14 255.255.255.252
ip ospf dead-interval minimal hello-multiplier 3
ip ospf 1 area 0
no negotiation auto
mpls ip
bfd interval 50 min_rx 50 multiplier 5
cdp enable
end
I have no QoS config. I am open to putting one on there to shape it down
to something less than 1G if needed to give BFD headroom.
Thank you.
_______________________________________________
cisco-nsp mailing list [email protected]
https://puck.nether.net/mailman/listinfo/cisco-nsp
archive at http://puck.nether.net/pipermail/cisco-nsp/
