Are you sure packet based storm-control is even supported in the platform? What does 'show storm-control' say?
It is interesting that all packets are multicast packets in the Ten interfaces, but the packet count is so low, I don't think we can put a lot of weight into it. On Thu, 4 Aug 2022 at 13:52, Joe Maimon <jmai...@jmaimon.com> wrote: > > Thanks for responding. I was looking for a controller like command to > see maybe there were some malformed frames or something, but couldnt > find one on this platform. > > > > Saku Ytti wrote: > > On Thu, 4 Aug 2022 at 02:06, Joe Maimon via cisco-nsp > > <cisco-nsp@puck.nether.net> wrote: > > > >> I have a vendor trying to turn up a 10gb link from their juniper mx to a > >> cisco 4900M, using typical X2 LR. > >> > >> The link was being upgraded from a functioning 1gb. Same traffic. > GigabitEthernet2/21 is up, line protocol is up (connected) > Hardware is Gigabit Ethernet Port, address is 588d.xxxx.a8f8 (bia > 588d.xxxx.a8f8) > Description: Cxxxxxxxxx 12.KFxxxxxxxxxxxxxxx > MTU 9198 bytes, BW 1000000 Kbit/sec, DLY 10 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation ARPA, loopback not set > Keepalive set (10 sec) > Full-duplex, 1000Mb/s, link type is auto, media type is 1000BaseLH > input flow-control is off, output flow-control is off > ARP type: ARPA, ARP Timeout 04:00:00 > Last input 00:00:00, output never, output hang never > Last clearing of "show interface" counters never > Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue: 0/40 (size/max) > 30 second input rate 263000 bits/sec, 147 packets/sec > 30 second output rate 663000 bits/sec, 201 packets/sec > 5900382712 packets input, 1369541098917 bytes, 0 no buffer > Received 100294521 broadcasts (100294050 multicasts) > 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored > 0 input packets with dribble condition detected > 7240868168 packets output, 6306357851288 bytes, 0 underruns > 0 output errors, 0 collisions, 3 interface resets > 0 unknown protocol drops > 0 babbles, 0 late collision, 0 deferred > 0 lost carrier, 0 no carrier > 0 output buffer failures, 0 output buffers swapped out > > interface GigabitEthernet2/21 > description Cxxxxxxxxx 12.KFxxxxxxxxxxxxxxx > switchport trunk allowed vlan 1660-1679 > switchport trunk native vlan 1001 > switchport mode trunk > switchport nonegotiate > switchport port-security maximum 100 > switchport port-security aging time 3 > switchport port-security aging type inactivity > switchport port-security > mtu 9198 > load-interval 30 > no cdp enable > storm-control broadcast level pps 10k > storm-control action shutdown > spanning-tree portfast edge > > > > > >> Even with switchport mode trunk and switchport allowed vlan none, with > >> input counters in single digits, storm control immediately takes the > >> port down after link up. There was negligible traffic on the link before > >> or after the attempt. > > Broadcast, multicast or unicast storm-control? What rate? Have you > > tried increasing the rate? Can you provide the logs of storm-control > > taking the port down? > > Gobs of this > > Aug 2 22:18:22: %PM-4-ERR_DISABLE: storm-control error detected on > Te1/3, putting Te1/3 in err-disable state > Aug 2 22:18:22: %STORM_CONTROL-3-SHUTDOWN: A packet storm was detected > on Te1/3. The interface has been disabled. > Aug 2 22:19:07: %PM-4-ERR_RECOVER: Attempting to recover from > storm-control err-disable state on Te1/3 > Aug 2 22:19:10: %PM-4-ERR_DISABLE: storm-control error detected on > Te1/3, putting Te1/3 in err-disable state > > Tried another X2 > > Aug 2 22:31:33: %C4K_IOSINTF-5-TRANSCEIVERREMOVED: Slot=1 Port=3: > Transceiver has been removed > Aug 2 22:31:48: %C4K_IOSINTF-5-TRANSCEIVERINSERTED: Slot=1 Port=3: > Transceiver has been inserted > Aug 2 22:31:50: %SFF8472-5-THRESHOLD_VIOLATION: Te1/3: Tx power low > alarm; Operating value: -40.0 dBm, Threshold value: -12.2 dBm. > Aug 2 22:32:09: %SYS-5-CONFIG_I: Configured from console by joe on vty0 > (216.222.148.103) > Aug 2 22:32:14: %PM-4-ERR_RECOVER: Attempting to recover from > storm-control err-disable state on Te1/3 > Aug 2 22:32:17: %PM-4-ERR_DISABLE: storm-control error detected on > Te1/3, putting Te1/3 in err-disable state > Aug 2 22:32:17: %STORM_CONTROL-3-SHUTDOWN: A packet storm was detected > on Te1/3. The interface has been disabled. > > Tried another port > > Aug 2 22:52:05: %C4K_IOSINTF-5-TRANSCEIVERINSERTED: Slot=3 Port=1: > Transceiver has been inserted > Aug 2 22:52:08: %LINK-3-UPDOWN: Interface TenGigabitEthernet3/1, > changed state to up > Aug 2 22:52:08: %STORM_CONTROL-3-FILTERED: A Broadcast storm detected > on Te3/1. A packet filter action has been applied on the interface. > Aug 2 22:52:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface > TenGigabitEthernet3/1, changed state to up > Aug 2 22:52:14: %STORM_CONTROL-3-FILTERED: A Broadcast storm detected > on Te3/1. A packet filter action has been applied on the interface. > Aug 2 22:52:17: %STORM_CONTROL-3-FILTERED: A Broadcast storm detected > on Te3/1. A packet filter action has been applied on the interface. > Aug 2 22:52:20: %STORM_CONTROL-3-FILTERED: A Broadcast storm detected > on Te3/1. A packet filter action has been applied on the interface. > Aug 2 22:52:23: %STORM_CONTROL-3-FILTERED: A Broadcast storm detected > on Te3/1. A packet filter action has been applied on the interface. > > noc12sw15#sh int te1/3 > TenGigabitEthernet1/3 is down, line protocol is down (notconnect) > Hardware is Ten Gigabit Ethernet Port, address is 6073.xxxx.ae82 (bia > 6073.xxxx.ae82) > Description: Cxxxxxxxxx 12.KFxxxxxxxxxxxxxxx > MTU 9198 bytes, BW 10000000 Kbit/sec, DLY 10 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation ARPA, loopback not set > Keepalive not set > Full-duplex, 10Gb/s, link type is auto, media type is No X2 > input flow-control is off, output flow-control is off > ARP type: ARPA, ARP Timeout 04:00:00 > Last input 1d11h, output never, output hang never > Last clearing of "show interface" counters never > Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue: 0/40 (size/max) > 30 second input rate 0 bits/sec, 0 packets/sec > 30 second output rate 0 bits/sec, 0 packets/sec > 27 packets input, 1732 bytes, 0 no buffer > Received 26 broadcasts (26 multicasts) > 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored > 0 input packets with dribble condition detected > 12 packets output, 864 bytes, 0 underruns > 0 output errors, 0 collisions, 5 interface resets > 0 unknown protocol drops > 0 babbles, 0 late collision, 0 deferred > 0 lost carrier, 0 no carrier > 0 output buffer failures, 0 output buffers swapped out > > TenGigabitEthernet3/1 is down, line protocol is down (notconnect) > Hardware is Ten Gigabit Ethernet Port, address is d48c.xxxx.ca50 (bia > d48c.xxxx.ca50) > MTU 9198 bytes, BW 10000000 Kbit/sec, DLY 10 usec, > reliability 255/255, txload 1/255, rxload 1/255 > Encapsulation ARPA, loopback not set > Keepalive set (10 sec) > Full-duplex, 10Gb/s, link type is auto, media type is No X2 > input flow-control is off, output flow-control is off > ARP type: ARPA, ARP Timeout 04:00:00 > Last input 1d11h, output never, output hang never > Last clearing of "show interface" counters never > Input queue: 0/2000/0/0 (size/max/drops/flushes); Total output drops: 0 > Queueing strategy: fifo > Output queue: 0/40 (size/max) > 5 minute input rate 0 bits/sec, 0 packets/sec > 5 minute output rate 0 bits/sec, 0 packets/sec > 42 packets input, 2688 bytes, 0 no buffer > Received 42 broadcasts (42 multicasts) > 0 runts, 0 giants, 0 throttles > 0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored > 0 input packets with dribble condition detected > 24 packets output, 1566 bytes, 0 underruns > 0 output errors, 0 collisions, 3 interface resets > 0 unknown protocol drops > 0 babbles, 0 late collision, 0 deferred > 0 lost carrier, 0 no carrier > 0 output buffer failures, 0 output buffers swapped out > > interface TenGigabitEthernet1/3 > description Cxxxxxxxxx 12.KFxxxxxxxxxxxxxxx > switchport trunk allowed vlan 1660-1679 > switchport trunk native vlan 1001 > switchport mode trunk > switchport nonegotiate > switchport port-security maximum 100 > switchport port-security aging time 3 > switchport port-security aging type inactivity > switchport port-security > mtu 9198 > load-interval 30 > no cdp enable > storm-control broadcast level pps 10k > storm-control action shutdown > no keepalive > no lldp transmit > no lldp receive > spanning-tree portfast edge > spanning-tree bpdufilter enable > > interface TenGigabitEthernet3/1 > mtu 9198 > storm-control broadcast level pps 10k > ! > > Current light > > Temperature Voltage Tx Power Rx Power > Port (Celsius) (Volts) (dBm) (dBm) > --------- ----------- ------- -------- -------- > Gi2/21 26.5 3.26 -6.0 -28.2 > > At that time, light was -4 -6 or -6 -4 > > Joe -- ++ytti _______________________________________________ cisco-nsp mailing list cisco-nsp@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-nsp archive at http://puck.nether.net/pipermail/cisco-nsp/