thank you very much for that info!! I checked under Preferences and optimize is not checked.
________________________________ From: bmead...@gmail.com <bmead...@gmail.com> on behalf of Brian Meade <bmead...@vt.edu> Sent: Wednesday, February 28, 2018 2:55 PM To: Hamu Ebiso Cc: Anthony Holloway; cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router Didn't read the whole thread but make sure CIPC doesn't have "Optimize for low bandwidth" checked in the preferences. This tries to force G.729. On Wed, Feb 28, 2018 at 3:52 PM, Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: Here is the region information. [cid:8f436bad-8c75-481a-999e-8abf58c113af] thank you very much for your help. ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com<mailto:avholloway%2bcisco-v...@gmail.com>> Sent: Wednesday, February 28, 2018 1:31 PM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router Regions are important for a working call flow, yes. However, regions only exist on CUCM, not on gateways. The way in which regions/codec selection could produce the issue your seeing is as follows: Dial Peer has g711ulaw on it CUCM SIP Trunk has Gateway-Region on it CIPC has Phone-Region on it Gateway-Region to Phone-Region is using 8kbps On Wed, Feb 28, 2018 at 12:30 PM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: Region is not define in the config but CUCM. Is that what you need? That is the only config I have. and don't see any region defined in the gateway. thanks hamu ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com<mailto:avholloway%2bcisco-v...@gmail.com>> Sent: Wednesday, February 28, 2018 11:19 AM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router But you didn't send all the information, because your output doesn't show the dial-peers. One method is to capture the output from "debug voip ccapi inout" and look for the following line "Outgoing Dial-peer=" You also didn't address the regions either. Can you send that too? On Wed, Feb 28, 2018 at 11:13 AM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: I was just trying to give you all the information so that you will be able to see the whole picture. Regarding your questions, I don't know how to check that. ________________________________ From: Anthony Holloway <avholloway+cisco-v...@gmail.com<mailto:avholloway%2bcisco-v...@gmail.com>> Sent: Wednesday, February 28, 2018 10:45 AM To: Hamu Ebiso Cc: cisco-voip voyp list Subject: Re: [cisco-voip] Need help configuring router for 911 with POTS Lines connected to FXO port on the router That's interesting that I asked for the dial-peer config, and you sent everything but. Do you know how to confirm which dial-peer the gateway is using? On Wed, Feb 28, 2018 at 10:38 AM Hamu Ebiso <hebiso2...@hotmail.com<mailto:hebiso2...@hotmail.com>> wrote: Below is gateway configuration isdn switch-type primary-ni ! ! trunk group FXO_EM hunt-scheme sequential translation-profile incoming Incoming ! ! trunk group Local hunt-scheme sequential translation-profile outgoing outbound ! ! trunk group LD translation-profile outgoing outbound ! voice-card 0 dspfarm dsp services dspfarm ! ! voice call send-alert voice rtp send-recv ! voice service voip ip address trusted list ipv4 10.170.99.12 ipv4 10.44.50.14 ipv4 10.44.50.39 no ip address trusted authenticate clid substitute name clid network-provided allow-connections h323 to h323 allow-connections h323 to sip allow-connections sip to h323 allow-connections sip to sip redirect ip2ip signaling forward unconditional fax protocol t38 nse force version 0 ls-redundancy 0 hs-redundancy 0 fallback pass-through g711ulaw no fax-relay sg3-to-g3 modem passthrough nse codec g711ulaw sip bind control source-interface Loopback0 bind media source-interface Loopback0 session transport tcp min-se 360 session-expires 360 ds0-num header-passing error-passthru registrar server expires max 600 min 60 early-offer forced midcall-signaling passthru no call service stop ! ! voice class uri 10 sip host ipv4:10.x.x.x host ipv4:10..x.x.x host ipv4:10..x.x.x voice class codec 1 codec preference 1 g711ulaw codec preference 2 g729r8 ! voice class codec 2 codec preference 1 g711ulaw ! ! ! ! voice translation-rule 1 rule 1 /^208343\(....\)$/ /1208343\1/ ! voice translation-rule 9 rule 1 /5.../ /1208343\0/ ! voice translation-rule 10 rule 1 /^911/ /911/ rule 2 /^9911/ /911/ ! voice translation-rule 15 ! voice translation-rule 30 rule 1 /^911/ /911/ rule 2 /^9911/ /911/ rule 4 /^9\(011.*\)/ /\1/ rule 9 /^9\(.*\)/ /\1/ ! ! voice translation-profile Add1 translate calling 91 translate called 1 ! voice translation-profile Inbound translate called 1 ! voice translation-profile Strip9 translate called 10 ! voice translation-profile block_profile translate calling 15 ! voice translation-profile outbound translate calling 10 ! ! crypto pki token default removal timeout 0 ! ! ! ! license udi pid CISCO3845-MB sn FOC123128X5 license accept end user agreement archive log config hidekeys username admin privilege 15 password 7 105D1F0C username svuntbd privilege 15 secret 5 $1$vRxN$nu4JPZttcuPskPHoSdQZx. ! ! controller T1 0/0/0 shutdown cablelength long 0db ! controller T1 0/1/0 shutdown cablelength long 0db ! ! ! ! ! ! interface Loopback0 ip address 10.x.x.x 255.255.255.128 ! interface GigabitEthernet0/0 description uplink to Lan1 ip address 10.x.x.x 255.255.255.252 duplex auto speed auto media-type rj45 ! interface GigabitEthernet0/1 description uplink to Lan2 ip address 10.x.x.x 255.255.255.252 duplex auto speed auto media-type rj45 ! router ospf 1 auto-cost reference-bandwidth 10000 network 10.0.0.0 0.0.255.255 area 10.0.0.0 ! ip forward-protocol nd ! ! no ip http server no ip http secure-server ! _______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net<mailto:cisco-voip@puck.nether.net> https://puck.nether.net/mailman/listinfo/cisco-voip
_______________________________________________ cisco-voip mailing list cisco-voip@puck.nether.net https://puck.nether.net/mailman/listinfo/cisco-voip
