If Layer 1 and Layer 2 are down there aren't too many possible problems:
1. Incorrectly configured SPIDs
2. Incorrectly configured ISDN switch-type
3. Bad cable connecting the router to the jack
4. Router hardware problem
5. Telco problem.
(that's all I can think of off the top of my head)
Remember that the SPIDs and the switch-type are configured in the physical
interface only (not the Dialer interface, if you have one). Give the telco
a call, most will have a number for ISDN Repair, just give them the SPIDs
and they can run a test to your equipemnt.
Here's some good info from Cisco on configs:
http://www.cisco.com/warp/customer/779/smbiz/service/configs/isdn/isdn_confi
gs.htm
And here's on Troubleshooting:
http://www.cisco.com/warp/cpropub/45/ISDN_TS.htm
Good luck,
Matt
""Sanjay.Padmanabhan"" <[EMAIL PROTECTED]> wrote
in message [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
>
>
>
> Hi Gurus,
> I have a small problem configuring a Cisco 1603 router. This router has a
> ethernet port and integrted BRI. I want a PC to dial into the BRi port of
> the router. Now the problem, I am Facing is that I can configure the BRI
> port. But when I check the ISDN status with the SH ISDN STAT commnad. the
> layer 1, and layer 2 are shown as deactivated. Any suggestions on this
will
> be appreciated.
> Rgds
> Sanjay
> ********************************************************************
> Any opinions, express or implied, presented are solely those
> of the author and do not necessarily represent those of
> Standard Chartered Group
> ********************************************************************
>
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
