Sorry, I was distracted when I was writing the previous answerl.
The correction is:
Lines 130 to 134 refer to vty's
"E. Carolina Arias S." wrote:
> MHO and ready to be fired if I'm wrong:
>
> c3640 can support async interfaces (modems card or async cards with
> octopus cable), I'm not sure but I think up to 128. I doesn't matter if
> physically you have them or not, they logically exists and are lines 1 to
> 128.
>
> Aux port corresponds to line 129 and lines 130 to 134.
>
> Here I include for you the show line and sh hard of one of my routers.
> You'll se I don't have the async ports for some lines and it says I don't
> have hw. Then the lines that I do have, correspond with the slot I have
> the modems card in.
>
> Hope this helps,
>
> PALMAS-UNINET#sh line
> Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns
> Int
> 0 CTY - - - - - 24 1
> 0/0 -
> 65 TTY - inout - - - 0 0
> 0/0 -
> 66 TTY - inout - - - 0 1
> 0/0 -
> 67 TTY - inout - - - 0 1
> 0/0 -
> 68 TTY - inout - - - 0 1
> 0/0 -
> 69 TTY - inout - - - 0 1
> 0/0 -
> 70 TTY - inout - - - 0 1
> 0/0 -
> 71 TTY - inout - - - 0 1
> 0/0 -
> 72 TTY - inout - - - 0 1
> 0/0 -
> 73 TTY - inout - - - 0 1
> 0/0 -
> 74 TTY - inout - - - 0 1
> 0/0 -
> 75 TTY - inout - - - 0 1
> 0/0 -
> 76 TTY - inout - - - 0 1
> 0/0 -
> 77 TTY - inout - - - 0 1
> 0/0 -
> 78 TTY - inout - - - 0 1
> 0/0 -
> 79 TTY - inout - - - 0 1
> 0/0 -
> 80 TTY - inout - - - 0 1
> 0/0 -
> * 129 AUX 9600/9600 - inout - - - 268 0
> 9138/42482 -
> * 130 VTY - - - - 1 367 0
> 0/0 -
> * 131 VTY - - - - 1 49 0
> 0/0 -
> 132 VTY - - - - 1 21 0
> 0/0 -
> 133 VTY - - - - 1 0 0
> 0/0 -
> 134 VTY - - - - 1 0 0
> 0/0 -
>
> Line(s) not in async mode -or- with no hardware support:
> 1-64, 81-128
>
> PALMAS-UNINET#sh ha
> Cisco Internetwork Operating System Software
> IOS (tm) 3600 Software (C3640-IS-M), Version 12.0(4)T, RELEASE SOFTWARE
> (fc1)
> ...
> Channelized E1, Version 1.0.
> Bridging software.
> X.25 software, Version 3.0.0.
> Primary Rate ISDN software, Version 1.1.
> 1 Ethernet/IEEE 802.3 interface(s)
> 1 FastEthernet/IEEE 802.3 interface(s)
> 3 Serial network interface(s)
> 16 terminal line(s)
> 1 Channelized E1/PRI port(s)
>
> cisco cabanaboy wrote:
>
> > What are all of these mysterious lines ? 0-134 ?
> > 1 con + 1 aux + ???tty +5 vty =135 ?????
> > please enlighten me
> > btw when i entered in
> > exec-timeout 0 0
> > it seemed to affect all of the lines
> > ******************************************************
> > C3640#conf t
> > Enter configuration commands, one per line. End with
> > CNTL/Z.
> > C3640(config)#line ?
> > <0-134> First Line number
> > aux Auxiliary line
> > console Primary terminal line
> > tty Terminal controller
> > vty Virtual terminalC3640(config)#line 0 ?
>
> > <1-134> Last Line number
>
> > <cr>
> >
> > C3640(config)#line 0 134 ?
> > <cr>
> >
> > C3640(config)#line 0 134
> > No physical hardware support for line 1
> > C3640(config-lin)#
> >
> > =====
> > ciscocabanaboy, CCNP-Voice, CCDP, MCSE, CNX, A+, N+, I-net+, BOFH...
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! Photos -- now, 100 FREE prints!
> > http://photos.yahoo.com
> >
> > ___________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> --
> E. Carolina Arias Serna
> Consorcio Red Uno
> Ingenierķa Datos
> Sector Servicios
> [EMAIL PROTECTED]
> 56244400 E4828
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
--
E. Carolina Arias Serna
Consorcio Red Uno
Ingenierķa Datos
Sector Servicios
[EMAIL PROTECTED]
56244400 E4828
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]