You can configure a FR switch by using the following set of commands
......for example .....a cisco router acting as a FR_Switch have its S0 and
S1 configured as,
interface Serial0
no ip address
encapsulation frame-relay
no ip mroute-cache
clockrate 64000
frame-relay interface-dlci 20
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 40 interface Serial1 20
!
interface Serial1
no ip address
encapsulation frame-relay
clockrate 64000
frame-relay interface-dlci 40
frame-relay lmi-type ansi
frame-relay intf-type dce
frame-relay route 20 interface Serial0 40
ALI SHEERAZ
MCSE+I, MCDBA, CCNA
>From: "M Z" <[EMAIL PROTECTED]>
>Reply-To: "M Z" <[EMAIL PROTECTED]>
>To: [EMAIL PROTECTED]
>Subject: Frame Relay switch
>Date: Wed, 14 Jun 2000 20:14:42 MST
>
>Would anyone kindly share how to config a Cisco router to act as a FR
>switch.
>
>Thanks in advance.
>
>Mz
>
>________________________________________________________________________
>Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
>
>___________________________________
>UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
>FAQ, list archives, and subscription info: http://www.groupstudy.com
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
