Collin,
Is this a FastEth0 Interface or a Eth0 Interface.....If your using one
of the
onboard Ethernet Interfaces they are 10Mb half-duplex and 20Mb
full-duplex....
So this is actually depending on what your using......You can either use the
following
speed 10
speed 20
speed 100 fas eth
speed 200 fas eth
duplex full
duplex half
Joe
Senior Network/Systems Engineer
CCNA
Luan Kim <[EMAIL PROTECTED]> wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> collin,
> try this:
>
> conf t
> int e0
> speed 10
> end
>
>
> ********************************************
> Luan T. Kim, MCSE, CCNA *
> Systems/Network Infrastructure Engineer *
> MP3.COM, INC. http://www.mp3.com *
> Phone: 858-623-7341 Cell: 858-382-3055 *
> Fax: 858-623-7400 Email: [EMAIL PROTECTED] *
> ********************************************
>
>
> On Wed, 21 Jun 2000, Collin Clark wrote:
>
> > Is there a way to change E0 on a 2600 router from 100Mbs to 10Mbs?
> >
> >
> > ___________________________________
> > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> > FAQ, list archives, and subscription info: http://www.groupstudy.com
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
