I am using 5.1(2) with VPN Client 1.1 It works great and was terribly
easy to setup. Using IKE Config Mode I only had to issue 5 or 6 commands to
the PIX, setup the client and we were routing to the inside. Using config
mode with wildcard pre-shared keys simplifies things tremendously, and it
assigns the VPN client an IP address form a range I specifiy on the PIX.
Easy management and accounting.
-----Original Message-----
From: Akuinnen [mailto:[EMAIL PROTECTED]]
Sent: Thursday, June 29, 2000 4:17 PM
To: Vern Stitt; [EMAIL PROTECTED]
Subject: Re: Cisco VPN Software
I've had all sorts of problems with the 5.1(1) software, which was removed
from the download list. Release 5.1(2) was supposed to address these issues.
Has anyone tried it? The cool thing about the 5.1 releases is the Xauth
James
On Thu, 29 Jun 2000, Vern Stitt wrote:
> Hey Daniel,
>
> I haven't seen the Cisco VPN Client 1.2 version yet.
>
> I do know that on a PIX, firmware 5.0.3 and below required version 1.0 and
> firmware 5.1 and above required version 1.1.
>
> I would advise sticking with 5.0.3 and 1.0 on a PIX just because of the
PIX
> firmware stability. I do agree that the 1.1 VPN Client was easier to setup
> because the defaults were the settings I wanted. In 1.0 I had to adjust
> almost everything.
>
> Vern Stitt
> CCNA, MCSE, Etc.
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
