And may I add that the command : router(config-if)#clock rate bps gave the following: %Error: This command applies only to DCE interfaces However int s0 which is shutdown does not give such error when the above command is applied to the interface. But that doesn't mean that it's already made a DCE. ---------------------- Forwarded by Babashola Madariola/C/Africa/Mobil-Notes on 07/06/2000 05:43 PM --------------------------- [EMAIL PROTECTED] on 07/06/2000 07:13:10 AM To: Babashola Madariola/C/Africa/Mobil-Notes cc: [EMAIL PROTECTED] Subject: Re: The command is: router(config-if)#clock rate bps Wenderson Duarte CCNA "Babashola Madariola" <[EMAIL PROTECTED]>@groupstudy.com on 06/07/2000 12:28:25 Please respond to "Babashola Madariola" <[EMAIL PROTECTED]> Sent by: [EMAIL PROTECTED] To: [EMAIL PROTECTED] cc: Subject: Hi Would like to know the commands issued to make a router a DCE. Thanks in advance ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]