I'm only aware of the environment command on some routers.
TGE_7513>sh environ ?
all All environmental monitor parameters
last Last environmental monitor parameters
table Temperature and voltage ranges
<cr>
TGE_7513>sh environ all
Arbiter type 1, backplane type 7513 (id 2)
Power supply #1 is 1200W AC (id 1), power supply #2 is 1200W AC (id 1)
Active fault conditions: none
Fan transfer point: 1%
Active trip points: none
15 of 15 soft shutdowns remaining before hard shutdown
1
0123456789012
Dbus slots: XXXXX X XXX X
card inlet hotpoint exhaust
RSP(6) 17C/62F 25C/77F 22C/71F
Shutdown temperature source is 'hotpoint' on RSP(6), requested RSP(6)
+12V measured at 12.17
+5V measured at 5.19
-12V measured at -12.03
+24V measured at 23.87
+2.5 reference is 2.48
PS1 +5V Current measured at 32.16 A (capacity 200 A)
PS1 +12V Current measured at 0.00 A (capacity 35 A)
PS1 -12V Current measured at 0.04 A (capacity 3 A)
PS1 output is 167 W
PS2 +5V Current measured at 19.61 A (capacity 200 A)
PS2 +12V Current measured at 0.00 A (capacity 35 A)
PS2 -12V Current measured at 0.13 A (capacity 3 A)
PS2 output is 103 W
> -----Original Message-----
> From: Kurdziel, Peter [mailto:[EMAIL PROTECTED]]
> Sent: Thursday, July 06, 2000 3:26 PM
> To: [EMAIL PROTECTED]
> Subject: temperature
>
>
> Hey,
>
> Can I view the temperature of a router with show cup?
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]