After entering 'tunnel mpls traffic-eng path-option 1 dynamic' the router crash.
The configuration is: ip cef mpls traffic-eng tunnels ! interface loopback 0 ip address 2.2.2.2 255.255.255.255 ! interface se 0.23 ip address 192.168.23.1 255.255.255.255 mpls traffic-eng tunnels ip rsvp bandwidth 1000 ! router ospf 0 network 192.168.23.0 0.0.0.255 area 0 mpls traffic-eng router-id Loopback0 mpls traffic-eng area 0 ! interface tunnel1 ip unnumbered loopback 0 tunnel destination 3.3.3.3 tunnel mode mpls traffic-eng tunnel mpls traffic-eng bandwidth 100 tunnel mpls traffic-eng priority 1 1 ! end When the command 'tunnel mpls traffic-eng path-option 1 dynamic' is entered, the following messages appear and it is necessary reload the router (physically). 8w5d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Tunnel1, changed state to down 8w5d: %LINK-5-CHANGED: Interface Loopback0, changed state to administratively down 8w5d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to down 8w5d: %LINK-3-UPDOWN: Interface Loopback0, changed state to up 8w5d: %LINEPROTO-5-UPDOWN: Line protocol on Interface Loopback0, changed state to up 8w5d: %OSPF-5-ADJCHG: Process 1, Nbr 3.3.3.3 on Serial0.23 from EXCHANGE to DOWN, Neighb or Down: Interface down or detached hbor Down: Interface down or detached 8w5d: %OSPF-4-NONEIGHBOR: Received database description from unknown neighbor 3.3.3.3 8w5d: %OSPF-5-ADJCHG: Process 1, Nbr 3.3.3.3 on Serial0.23 from LOADING to FULL, Loading Done 8w5d: %LINK-3-UPDOWN: Interface Tunnel1, changed state to up Queued messages:Local Timeout (control reg=0x118) Error, address: 0x20201FE at 0x34CEA50 (PC) I also tried explicity path; the result is the same. And IS-IS too. Any Thoughts? Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=70221&t=70221 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]