Hi
Can somebody let me know what exact keyword (not icmp type number) should
be used
to enable the incoming access-list for trace route unix application to work
fine...
I know UDP should be allowed for outgoing and ICMP should be allowed for
the incoming...
Looking for the incoming side icmp access list "key words"
For looking these keywords I did the following on the router, But its a lot
and do not know
which one required for unix traceroute.
access-list 101 permit icmp any any ?
ICMP message type
administratively-prohibited Administratively prohibited
alternate-address Alternate address
conversion-error Datagram conversion
dod-host-prohibited Host prohibited
dod-net-prohibited Net prohibited
echo Echo (ping)
echo-reply Echo reply
fragments Check non-initial fragments
general-parameter-problem Parameter problem
host-isolated Host isolated
host-precedence-unreachable Host unreachable for precedence
host-redirect Host redirect
host-tos-redirect Host redirect for TOS
host-tos-unreachable Host unreachable for TOS
host-unknown Host unknown
host-unreachable Host unreachable
information-reply Information replies
information-request Information requests
log Log matches against this entry
log-input Log matches against this entry, including
input interface
mask-reply Mask replies
mask-request Mask requests
mobile-redirect Mobile host redirect
net-redirect Network redirect
net-tos-redirect Net redirect for TOS
net-tos-unreachable Network unreachable for TOS
net-unreachable Net unreachable
network-unknown Network unknown
no-room-for-option Parameter required but no room
option-missing Parameter required but not present
packet-too-big Fragmentation needed and DF set
parameter-problem All parameter problems
port-unreachable Port unreachable
precedence Match packets with given precedence value
precedence-unreachable Precedence cutoff
protocol-unreachable Protocol unreachable
reassembly-timeout Reassembly timeout
redirect All redirects
router-advertisement Router discovery advertisements
router-solicitation Router discovery solicitations
source-quench Source quenches
source-route-failed Source route failed
time-exceeded All time exceededs
timestamp-reply Timestamp replies
timestamp-request Timestamp requests
tos Match packets with given TOS value
traceroute Traceroute
ttl-exceeded TTL exceeded
unreachable All unreachables
Can somebody please let me know which keywords should be used for
traceroute to work fine.?
Thank you
Regards
Shibu
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=71662&t=71662
--------------------------------------------------
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
