If you have only one type of load then thats all you have to take, but in
your case you can find the load for both. . . remember that a serial link is
full duplex so you can actually recieve and send at the same time. That
will help you find out the load of your transmit (txload) and recieve
(rxload) at the same time. In the example output you gave there is no load
becaue both are at 1.
Another good thing to look at is your 5 minute input output rate. By
looking at yours its easy to see that you have very little trafic on that
line at all.
Rishard
""frank"" <[EMAIL PROTECTED]> wrote in message
8mjhn4$8h4$[EMAIL PROTECTED]">news:8mjhn4$8h4$[EMAIL PROTECTED]...
Do you mean we should pay attention to "txload" and "rxload"?Could you
explain in details?
Thanks.
frank
Router#sh int s0/0
Serial0/0 is up, line protocol is up
Hardware is PowerQUICC Serial
Internet address is **************
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec,
reliablility 255/255, txload 1/255, rxload 1/255
Encapsulation HDLC, loopback not set
Keepalive set (10 sec)
Last input 00:00:01, output 00:00:00, output hang never
Last clearing of "show interface" counters 4d05h
Queueing strategy: fifo
Output queue 0/40, 0 drops; input queue 0/75, 0 drops
5 minute input rate 0 bits/sec, 1 packets/sec
5 minute output rate 1000 bits/sec, 2 packets/sec
987106 packets input, 430840629 bytes, 0 no buffer
Received 36273 broadcasts, 0 runts, 0 giants, 0 throttles
677 input errors, 528 CRC, 146 frame, 0 overrun, 0 ignored, 3 abort
1103552 packets output, 120751866 bytes, 0 underruns
0 output errors, 0 collisions, 39 interface resets
0 output buffer failures, 0 output buffers swapped out
0 carrier transitions
DCD=up DSR=up DTR=up RTS=up CTS=up
"Rishard Chapoteau" <[EMAIL PROTECTED]> wrote in message
8mfalt$e6t$[EMAIL PROTECTED]">news:8mfalt$e6t$[EMAIL PROTECTED]...
Easy enough to check. Do a sho int s0, and look at the load. Take that # /
# and divide them. That will give u the utilization on that line.
Risard
""gary"" <[EMAIL PROTECTED]> wrote in message
000a01bffd11$cdffd4b0$4c00005a@gary">news:000a01bffd11$cdffd4b0$4c00005a@gary...
anyone can tell me how to get the utilization rate of bandwith of cisco
router's0
my client complain the speed is very slow.
i just want to check whether the bandwith is enough, otherwise, i will
improve the bandwith
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
