I think you said that you see traffic going out one tunnel, but not coming in on the other end of the tunnel. How are you checking that? What does your mroute cache look like for the group in question? Does it list the tunnel interface as an outgoing interface? On the end that isn't receiving anything, is it configured for the RP? Does it find the RP successfully? Does it know about the group in it's mroute cache?
Fred Reimer - CCNA Eclipsys Corporation, 200 Ashford Center North, Atlanta, GA 30338 Phone: 404-847-5177 Cell: 770-490-3071 Pager: 888-260-2050 NOTICE; This email contains confidential or proprietary information which may be legally privileged. It is intended only for the named recipient(s). If an addressing or transmission error has misdirected the email, please notify the author by replying to this message. If you are not the named recipient, you are not authorized to use, disclose, distribute, copy, print or rely on this email, and should immediately delete it from your computer. -----Original Message----- From: alaerte Vidali [mailto:[EMAIL PROTECTED] Sent: Wednesday, July 16, 2003 3:55 PM To: [EMAIL PROTECTED] Subject: RE: Multicasting [7:72403] I have configured it same time ago; the serial link was frame relay. But I used point-to-point subinterface Something like that: R1 interface tunnel 0 ip address 172.16.1.1 255.255.255.252 ip pim sparse-dense-mode tunnel source 192.168.1.1 tunnel destination 192.168.1.2 ! inter ser 0 encap frame-relay ! inter ser 0.1 point ip ad 192.168.1.1 255.255.255.252 frame-relay map interface-dlci 100 Same for R2. Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=72437&t=72403 -------------------------------------------------- FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
