a) look at menu command options. b) could not get the question c) map your local IP to local DLCI d) is this back to back, then put the clock rate command where the DCE cable is connected
Regards Devvvv ----- Original Message ----- From: "Shab Hanon" To: Sent: Sunday, August 03, 2003 12:04 PM Subject: IP services, from case study ... [7:73435] > Hi, > This is from a case study .... Can any one help on these ? > > > > a) Setup Rxx such that when a user telnets to it they will receive a menu > system that consists of the following options. > > Ability to display the IP routing table > Ability to clear the IP routing table > Ability to print off a Cisco TAC troubleshooting screen > Exit to command line interface > > > > b) When issuing a telnet session from Rxx ensure that the destination IP > address is not shown in the display. > > > c) R1, R2 & R6 are not allowed subinterfaces on the frame-relay network > that commonly connects them. R1, R2, R5 and R6 should be able to ping their > own interfaces. > > " how it can be possible to ping it their own interfaces on a serial ??? " > > > d) Make sure the frame-relay connection between R1 and R2 has a speed of > 128k > > > > Cheers, > Shab > **Please support GroupStudy by purchasing from the GroupStudy Store: > http://shop.groupstudy.com > FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Message Posted at: http://www.groupstudy.com/form/read.php?f=7&i=73437&t=73435 -------------------------------------------------- **Please support GroupStudy by purchasing from the GroupStudy Store: http://shop.groupstudy.com FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
