GDay Everyone,
Just hoping you all may be able to shed some light
onto this for me. This is the fist time I have tired to configure FXS ports
and its proving to be getting the better of me. I have 2 routers (2610XM)
connected together via a serial back to back. in each of these routers I
have a VIC-2FXS card in each NM-2V module. I have followed a basic
configuration
and I get a dial tone in the ear handset but for the life of me I am
continually getting a busy tone from each phone. When the phone is taken off
hook I do get a green light on the vic. Below is the configuration
Router A
hostname Router-A
voice-port 1/0/0
voice-port 1/0/1
dial-peer voice 1 pots
destination-pattern 1111
port 1/0/0
dial-peer voice 2 voip
destination-pattern 2222
session target ipv4:10.1.1.2
interface Serial0/0
ip address 10.1.1.1 255.255.255.0
no fair-queue
Router B
hostname Router-B
voice-port 1/1/0
voice-port 1/1/1
dial-peer voice 1 pots
destination-pattern 2222
port 1/1/0
dial-peer voice 2 voip
destination-pattern 1111
session target ipv4:10.1.1.1
interface Serial0/0
ip address 10.1.1.2 255.255.255.0
no fair-queue
clockrate 4000000
I can ping from either router the other router OK. Any thoughts would be of
great advantage. Thanks for you assistance
John
Message Posted at:
http://www.groupstudy.com/form/read.php?f=7&i=74283&t=74283
--------------------------------------------------
**Please support GroupStudy by purchasing from the GroupStudy Store:
http://shop.groupstudy.com
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
