The 1900 and 2900 dont run the same software.
There are even two sets of 2900's - each with a different command set. Which
one of them shares with the 5000. Etc Etc Etc
A good guide to all of this apart from the CD or CCO (which has everything
you want) was the CLSC course material for the CCNP 1 exam. A lot easier to
read on the train than a laptop running the cd. ;-)
The functions are very similar for all the switches so using the same logic
you should be able to figure anything out using the manual or CCO. Came
across an old 3xxx switch - took 20 minutes of digging on the CD to find the
password recovery procedure. And another 5 to figure out when they said
press "break" they actually meant a button on the router as opposed to
alt-break (blush).
----- Original Message -----
From: "Sim, CT (Chee Tong)" <[EMAIL PROTECTED]>
To: "'Adam Hickey'" <[EMAIL PROTECTED]>; <[EMAIL PROTECTED]>
Sent: Thursday, August 10, 2000 8:46 PM
Subject: Why the format is different for my 1900 and 2900
>
> Dear all, Why the format is different for my 1900 and 2900? when I telnet
> to my 1900, after typing the password, it straight give me the screen
below.
> It is not the same as the 2900 configuration that I can see my conf file
>
>
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
> $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
> Catalyst 1900 - Main Menu
>
> [C] Console Settings
> [S] System
> [N] Network Management
> [P] Port Configuration
> [A] Port Addressing
> [D] Port Statistics Detail
> [M] Monitoring
> [B] Bridge Group
> [R] Multicast Registration
> [F] Firmware
> [I] RS-232 Interface
> [U] Usage Summaries
> [H] Help
>
> [X] Exit Management Console
>
> Enter Selection:
>
>
$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
> $$$$$$$$$$$$$$$$$$$$$$$$$$$$$$
>
> Cat2900#sh conf
> Using 1662 out of 32768 bytes
> !
> version 11.2
> no service pad
> no service udp-small-servers
> no service tcp-small-servers
> !
> hostname Cat2900
> !
> enable secret 5 $1$5Iz6$VIgXgKHrRr9QhPFxHJs7k1
> !
> !
> !
> interface VLAN1
> ip address 57.198.165.248 255.255.254.0
> no ip route-cache
> !
> interface FastEthernet0/1
> !
> interface FastEthernet0/2
> duplex full
> spanning-tree vlan 1 cost 50
> !
>
> ==================================================================
> De informatie opgenomen in dit bericht kan vertrouwelijk zijn en
> is uitsluitend bestemd voor de geadresseerde. Indien u dit bericht
> onterecht ontvangt wordt u verzocht de inhoud niet te gebruiken en
> de afzender direct te informeren door het bericht te retourneren.
> ==================================================================
> The information contained in this message may be confidential
> and is intended to be exclusively for the addressee. Should you
> receive this message unintentionally, please do not use the contents
> herein and notify the sender immediately by return e-mail.
>
>
> ==================================================================
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
