Make sure that your config register is set to 0x2012 some register settings
will cause the boot process to ignore NVRAM.
Arya
>From: [EMAIL PROTECTED]
>Reply-To: [EMAIL PROTECTED]
>To: [EMAIL PROTECTED]
>Subject: cisco 2504 problem
>Date: Mon, 21 Aug 2000 10:59:10 +1000
>
>ok techies...
>here is a problem i been trying to sort out for a quite a little time now
>this router I purchased recently seems ok nothing is broken boots ok now
>the problem is everytime it boots up it has forgotten what the last
>configuration was I mean I always make config changes and give the comman
>"copy run star" and no error pops up but when I turn it off and back on
>again and there is stupid message asking me to redo the whole damn config
>file could someone tell me if it is the Flash or the IOS itself or
>something else that could be wrong with the router.
>
>Regards,
>Amir
>
>___________________________________
>UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
>FAQ, list archives, and subscription info: http://www.groupstudy.com
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
