You are going to be very limited in what you can do with this scenerio. You aren't going to be running any IGP/EGP's with the providers. You can't route between the providers since they won't allow addresses from one network to transit the other. You can't do any kind of load balancing since your source ip will be different for each packet/session. You could maybe setup nat, and work some failover scenerios with static routes and the like though. On Sun, 27 Aug 2000, Sammi wrote: > Ok, I was drawn out in another thread so I'll pop a question while I'm > delurked. > I currently have cable internet access, scheduled to have DSL added in > a couple weeks. So I will have two feeds and 4 IP's. > I have 5 PCs and one NT server currently up and running. > One Bay Networks Baystack 101 12 port 10BaseT hub. I believe it will > support segmenting. > My question; what sort of design should I attempt here for learning > purposes? I'd like to pick up some routers, perhaps one every two > months on my budget, figuring probably three will be needed? 25xx > series? > I'm really just thrashing, trying to figure out what it is I should > build. Perhaps I should begin studies for CCDA and in the course of my > studies the solution will come? > Any comments, suggestions, etc. always appreciated. > > ___________________________________ > UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html > FAQ, list archives, and subscription info: http://www.groupstudy.com > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED] > ----------------------------------------------- Brian Feeny, CCNA, CCDA [EMAIL PROTECTED] Network Administrator ShreveNet Inc. (ASN 11881) ___________________________________ UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html FAQ, list archives, and subscription info: http://www.groupstudy.com Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]