I have 2 2500's hooked up back to back. I used the command show controller
s 0 etc to make sure that the router was identifying the cable correctly.
Look for the DCE or DTE setting that appears in the output from this
command.
I then set the clock rate on the DCE ports that have the cables attached
using the command "clockrate 4000000" THis is the highest throughput I
could get on this port.
I havent put in any encapsulation or anything like that. Mine works
fine...I can route traffic through it without a problem.
I would be interested to hear if anyone has actually had success configuring
it to work properly setting the different ecapuslations etc
Cheers
Douwe
-----Original Message-----
From: Ravi Kumar [mailto:[EMAIL PROTECTED]]
Sent: Saturday, August 26, 2000 3:08 PM
To: Zhang Hui; [EMAIL PROTECTED]
Subject: 2610 routers back to back
hi friends
i too have one doubt
I am going to buy two 2610 routers for my training center.
will a CSU/DSU cable, which is working with 2500 series routers, work with
2610 routers also? or shall i go for new one??
over all two 2610 routers can be connected back to back through leased line
ports for training????
your earliest valuble input is highly appreciated.
with regards
"Zhang Hui" <[EMAIL PROTECTED]> wrote:
Hi,there:
I connected router 2611's serial0/0 to 2501's serial1 with a DTE to DCE
cable, and set clockrate ,keepalive,encap HDLC. But they could not work yet.
Who can help me ?
Thanks in advance...
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
____________________________________________________________________
Get free email and a permanent address at http://www.netaddress.com/?N=1
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
Visit our Website : http://www.traveland.com.au
Disclaimer - This message and any attachments are confidential and may contain
privileged information intended only for the use of the addressee named above. If you
are not the intended recipient of this message you are hereby notified that any use,
dissemination, distribution or reproduction of this message is prohibited. If you have
received this message in error please notify Traveland Pty Ltd immediately by return
email. Any views expressed in this message are those of the individual sender and may
not necessarily reflect the views of Traveland Pty Ltd.
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
