clock
rate is normally omitted if your router's DTE interface is connected to a
CSU/DSU since the modem will provide the clock rate information. However if you
are in a lab scenario whereby you are simulating a Wan by connecting your DTE to
your DCE using two Cisco cables then at the DCE end you have to provide the
clock rate in order that your serial interface can be up and
running.
However , bandwidth needs to be supplied no matter you
are in lab or practical environments because things like reliability , load etc
depends on it to work. Hope that helps
Jason
|
- Command Question Adam Hickey
- Re: Command Question Reinhold Fischer
- Re: Command Question analogkid01
- Re: Command Question Chris Larson
- Re: Command Question Yee, Jason
- Re: Command Question Cisco Kid
- RE: Command Question Yee, Jason
- RE: Command Question Roger Dellaca