yeah, check your port on your cat5k switch where your printer is connected.
make sure you have enabled port fast, and hard-coded the speed and duplex of
that port.
-Brad
""Sites, Bob"" <[EMAIL PROTECTED]> wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]..
.
> Trying to configure an IBM 7913 coax/twinax for a printer using BootP from
> out AIX UNIX server. For some reason we cannot get it to flow through our
> C5509 and C5500 switches. Before we installed the switches, using purely
> Cisco routers this was not a problem. Bootp is the only option to
configure
> these devises. Have tried BootP programs from a laptop but are not working
> either. Could be the Win2000 conflicting with my old pgms. We have IP
Helper
> turned on pointing to the BootP server. Any ideas?
>
> Bob Sites
> System Engineer, CCNA
>
> ___________________________________
> UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
> FAQ, list archives, and subscription info: http://www.groupstudy.com
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> ---
___________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
