That is illogical. The switch shouldn't care if it's a DB9 or DB25 on the
other end of the cable. Connect to the console port and Power cycle the
switch. If you see Gibberish, the Baud Rate is wrong. 9600 is the default,
but depending on the config-register, it could be 9600,4800,2400, or 1200.
(Other comm settings are 8,none,1)
----Original Message Follows----
From: "Hans Schimek" <[EMAIL PROTECTED]>
Reply-To: "Hans Schimek" <[EMAIL PROTECTED]>
To: <[EMAIL PROTECTED]>
Subject: Configuring Catalyst 1200 ?
Date: Fri, 15 Sep 2000 22:10:40 +0200
i got a catalyst 1200 .
it cannot be configured via the
db-9 to RJ45 cable.
the documentation says that i have to use the db25 to RJ45 cable.
but i do not have a second COM Port with an RS232 interface.
any advice ?
thanx
hans
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
Share information about yourself, create your own public profile at
http://profiles.msn.com.
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
