BINGO- I have been using this MAU on Ring 16 forever & thought the battery
was going out. As you mentioned, it was goofy most the time (@ 16). I have
Ring 4 & it's smooth sail'n (I'm but so excited- it's only Token Ring :-)
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.5.5.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/5/8 ms
Router#ping 195.5.5.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.5.5.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/8 ms
Router#ping 195.5.5.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.5.5.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/8 ms
Router#ping 195.5.5.5
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 195.5.5.5, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 4/4/8 ms
Thanks Everyone !!!
Phil
----- Original Message -----
From: Dave Hennen
To: Circusnuts ; [EMAIL PROTECTED]
Sent: Monday, September 18, 2000 1:19 PM
Subject: RE: MAU trouble shooting
I assume you've tried different ports and different cables
If it's a real IBM mau you may have to reinitialize the port. there is a
battery powered tool that used to come with the mau. It also could be a
speed mismatch if the mau has a way to set the ring speed. There used to be
4mbps only media filters (back in the day) if you are using one of those on
a 16mbps ring, weird things can happen.
daveh
-----Original Message-----
From: Circusnuts [mailto:[EMAIL PROTECTED]]
Sent: Sunday, September 17, 2000 6:05 AM
To: [EMAIL PROTECTED]
Subject: MAU trouble shooting
Does this mean my MAU is fried ??? It has never come off initializing (left
the routers run connected all night)...
TokenRing0 is initializing, line protocol is down
Hardware is TMS380, address is 0000.30c0.ec2a (bia 0000.30c0.ec2a)
Internet address is 195.5.5.10/24
MTU 4464 bytes, BW 16000 Kbit, DLY 630 usec, rely 255/255, load 1/255
Encapsulation SNAP, loopback not set, keepalive set (10 sec)
ARP type: SNAP, ARP Timeout 04:00:00
Ring speed: 16 Mbps
Single ring node, Transparent Bridge capable
Source bridging enabled, srn 49904 bn 0 trn 49904
proxy explorers disabled, spanning explorer disabled, NetBIOS cache
disable
Thanks !!!
Phil
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
