Hi. I was wondering if anyone could help. I have a Cisco 1601 and no
console cable. Based on what I have learned online, I have done the
following:
1. I took a cat-5 straight through cable, pulled off the rj-45 connector
and stuck it back on upside down to make a roll-over cable.
2. I purchased a RJ45/DB9F adapter.
The problem is that the RJ45/DB9F adapter comes in two pieces and the
wires
must be manually inserted into the DB9F (serial) side of the adapter
from
the RJ45 side of the adapter. I'm not sure which wire goes where.
There are 8 wires:
1. slate (gray)
2. brown
3. yellow
4. green
5. red
6. black
7. orange
8. blue
There are 9 numbered holes on the DB9F side of the adapter. Does anyone
know which wire goes in which hole (i.e., slate wire goes in hole 1,
etc.)?
Thanks,
Scott
**NOTE: New CCNA/CCDA List has been formed. For more information go to
http://www.groupstudy.com/list/Associates.html
_________________________________
UPDATED Posting Guidelines: http://www.groupstudy.com/list/guide.html
FAQ, list archives, and subscription info: http://www.groupstudy.com
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
