You do not have any users with passwords specified. PAP will not
authenticate without these. You need to do -----
username central password whatever. You should have this on both of your
routers.
as for the line dialer map ip 192.168.0.1 name central broadcast 20
you have specified the word broadcast here. This is not needed as you are
not running any routing protocols. You are indeed using static routing.
The word broadcast is used to allow the flow of routing updates across the
ISDN line when it becomes active.
Hope this helps!
-----Original Message-----
From: Hans Schimek [mailto:[EMAIL PROTECTED]]
Sent: 19 October 2000 21:14
To: [EMAIL PROTECTED]
Subject: ISDN calls gets connected but disconnects immediately
hi!
i am simulating an isdn call on an isdn switch with 2 S0 interfaces.
i am trying to configure DDR . as i am trying to ping the remote
router ( 192.168.0.1 ) the call gets initiated but gets disconnected
immediately.
i included the output of the isdn q931 command and my running config.
any advice ?
thanx in advance
=============================
Hans Schimek
Student
Fachhochschule St. P�lten f.
Telekommunikation und Medien
mailto: [EMAIL PROTECTED]
gsm : +43 699 10605315
fax : +43 3613 2311 4
icq : 22308773
www : www.schimek.net
=============================
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
