Jeff,
OSPF uses areas. They are defined under the router config mode under ospf
using the network command. All OSPF areas together is one AS. The process
id # actually is meaningless. The # can be used so that you can have more
than 1 instance of OSPF running on the same router. This is not even
recommended to do and there are no really good reasons to do it.
HTH
Cory
-----Original Message-----
From: Jeff McCoy [mailto:[EMAIL PROTECTED]]
Sent: Tuesday, November 07, 2000 8:26 AM
To: [EMAIL PROTECTED]
Subject: ospf process id / AS??
If the process id is defined as 200 in the command:
router ospf 200
and this is not the AS, then where is the AS defined?
-jm
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
