Group,
I am trying to configure the Teltone ISDN demonstrator, however when I
connect the bri int to it and do a sh isdn stat I get the following:
router1#sh isdn stat
Global ISDN Switchtype = basic-ni
ISDN BRI0 interface
dsl 0, interface ISDN Switchtype = basic-ni
Layer 1 Status:
ACTIVE
Layer 2 Status:
TEI = 116, Ces = 1, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI = 117, Ces = 2, SAPI = 0, State = MULTIPLE_FRAME_ESTABLISHED
TEI 116, ces = 1, state = 8(established)
spid1 configured, spid1 sent, spid1 NOT valid
TEI 117, ces = 2, state = 8(established)
spid2 configured, spid2 sent, spid2 NOT valid
Layer 3 Status:
0 Active Layer 3 Call(s)
Activated dsl 0 CCBs = 0
The Free Channel Mask: 0x80000003
Total Allocated ISDN CCBs = 0
This config does not seem to be right since my spid's are not valid, I have
double checked the spids and DN's. Any config tips on the switch ?
Thanks in advance,
George
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
