It must be a Traffic Director problem because I have the same problem using
5.8a with a Catalyst 3548 and the 2924 switches. I did notice that this was
not the case in v5.7 or before. When I tried to install the agents it had an
error communicating. When I test the agent it comes back fine and it even
learns the ports when I configure a new unit.
The message that you listed is what I get on the interfaces that I can still
get polling on and the ones that do not work.
"Ryan Ngai Hon Kong" <[EMAIL PROTECTED]> wrote in message
4176F37FBF9DD411B38700306E0114540F2A4E@JOSEXCHG">news:4176F37FBF9DD411B38700306E0114540F2A4E@JOSEXCHG...
> Hi,
>
> Does anyone have experience configuring the HP LanProbe III (RMON 1) with
> Traffic director 8.1?
> I had install the lanprobe with an IP and as an agent. When I test the
> probe, it returns
> the following string.
>
> General info:
> IP Address: 10.1.5.106
> Ping: Not supported
> Read Community: "public" OK
> Write Community: "public" OK
>
> SNMPv1 Protocol: Supported
> Protocol Monitoring: Disabled or Not Supported
> Application Monitoring: Disabled or Not Supported
> High-Capacity Monitoring: Disabled or Not Supported
> Application Response time: Disabled or Not Supported
> Resource Monitoring: Disabled or Not Supported
>
> Interface info:
> Interface Number: 1
> Description: HP LP-III Intel 82596
> Interface type: ethernet csmacd (6)
> Physical Address: xx-xx-xx-xx-xx-xx
> Number of Interface: 2
> Net Speed: 10 Mbit/sec
>
>
> What I observe from this string is that I will not be able to perform
> traffic monitoring
> or even segment zoom into the lan probe because it says "Error Accessing
> Agent Rmon-agent1(10M)! While
> retrieving ETSTATS. Error: Entry or Group not present in Agent". The group
> of agent and the agent itself
> is configured properly. Even with the new HP LanProbe (RMON 2) doesn't
help
> either.
>
>
> Please advice.
> Thanks.
> Ryan
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/
cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
