How do you fix that problem if it is your access server and only the
loopback is configured?
""Rodgers Moore"" <[EMAIL PROTECTED]> wrote in message
8vc2rn$so9$[EMAIL PROTECTED]">news:8vc2rn$so9$[EMAIL PROTECTED]...
> I've had a similar problem when I loaded an IOS that was able to fit in
> flash, but I didn't have the recommended amount of RAM installed on the
> router. Another possibility is the baud rate has been configured on the
> console port, so it runs default 9600 up until the config file is loaded
> then runs at the new speed set in the config file.
>
> Rodgers Moore
>
> ""Austin"" <[EMAIL PROTECTED]> wrote in message
> 8vb8tg$mnt$[EMAIL PROTECTED]">news:8vb8tg$mnt$[EMAIL PROTECTED]...
> > I have a Cisco 2511 and the console has locked all of a sudden.
> > I get output from the boot sequence, but after it gives me the memory
> stats,
> > nothing.
> > It does not respond to hitting the enter key ... nothing.
> > Any thoughts on this??
> >
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
