----- Original Message -----
From: "Ben Hockenhull" <[EMAIL PROTECTED]>
>
> Trouble is that I seem to be having problems finding an IOS image that
> actually supports the FXO or FXS VIC. I know I need a Plus image, and I
> presume I need the voice feature set as well.
>
> I've tried various 12.1.xT IP/Voice/Plus/etc images, and none of them seem
> to support the VIC. I do a show voice port and it returns blank. The
> amber in use lights on the VIC ports are lit, even though there's nothing
> plugged in. I should also get dialtone on an FXS port regardless of
> config, and there's no dice there.
>
> Anyone know what might be going on? Suggestions for a known-working 1750
> image that actually supports the VICs?
12.1.3T IP/Voice+ works for sure.
(c1700-sv3y-mz.121-3.T)
Do you have PVDM dsp module installed?
The 'show dsp' looks like:
BOOT PAK
TYPE DSP CH CODEC VERS STATE STATE RST AI PORT TS ABORT TX/RX-PAK-CNT
==== === == ======== ==== ===== ======= === == ======= == ===== ===============
DSP# 0: state IN SERVICE, 2 channels allocated
channel# 0: voice port 1/0, codec g723r63, state UP
channel# 1: voice port 1/1, codec g723r63, state UP
Another cause of your problems could be the newer version
of FXO VICs - i.e. the VIC-2FXO-EU-M2 is not
supported yet in c1750 - I must exchange it for normal EU version.
I dont know if any new FXS modules have similar issues.
See the 'show diag' output:
EU-M2 VIC is detected as unknown.
WIC Slot 1:
Dual FXO EU Voice Interface Card WAN daughter card
Hardware revision 1.0 Board revision B0
Serial number 0015079920 Part number 800-03639-02
Test history 0x00 RMA number 00-00-00
Connector type WAN Module
EEPROM format version 1
EEPROM contents (hex):
0x20: 01 16 01 00 00 E6 19 F0 50 0E 37 02 00 00 00 00
0x30: 58 00 00 00 99 08 05 01 FF FF FF FF FF FF FF FF
P/
Packet Voice DSP Module:
Hardware Revision : 2.2
Part Number : 73-3741-01
Board Revision : A0
Deviation Number : 0-0
Fab Version : 02
PCB Serial Number : ICP033500JV
RMA Test History : 00
RMA Number : 0-0-0-0
RMA History : 00
Processor type : 02
Number of DSP's : 1
Type of DSP : TMS320C549
EEPROM format version 4
EEPROM contents (hex):
0x00: 04 FF 40 01 5A 41 02 02 82 49 0E 9D 01 42 41 30
0x10: 80 00 00 00 00 02 02 C1 8B 49 43 50 30 33 33 35
0x20: 30 30 4A 56 03 00 81 00 00 00 00 04 00 09 02 FF
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]