8-N-2 is correct, but 8-N-1 should work, too. Did you check the speed? 9600 might not be correct. Make sure config register was not changed.
HTH,
Rog
PS. Hello, Ric.
> -----Original Message-----
> From: Ric Messier [mailto:[EMAIL PROTECTED]]
> Sent: Wednesday, November 29, 2000 1:06 PM
> To: Barbara Cobbina; [EMAIL PROTECTED]
> Subject: RE: garbage in hperterminal ?
>
>
> Isn't it 8-N-1?
>
> > -----Original Message-----
> > From: [EMAIL PROTECTED]
> [mailto:[EMAIL PROTECTED]]On Behalf Of
> > Barbara Cobbina
> > Sent: Wednesday, November 29, 2000 10:13 AM
> > To: [EMAIL PROTECTED]
> > Subject: garbage in hperterminal ?
> >
> >
> > Can anyone please tell me why I get garbage in
> > hyperterminal when I try to access my 2503 from the
> > console.
> >
> > My settings are 9600-8-N-2 and I think I have the
> > right cable as it worked before.
> >
> > Cheers
> > Babs
> >
> > __________________________________________________
> > Do You Yahoo!?
> > Yahoo! Shopping - Thousands of Stores. Millions of Products.
> > http://shopping.yahoo.com/
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> > http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to
> [EMAIL PROTECTED]
> >
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]