Thanks for the replies! Solved for now, but I'm not sure what was wrong -
perhaps a loose cable ?
Bharat
""Bharat Suneja"" <[EMAIL PROTECTED]> wrote in message
91n57o$24g$[EMAIL PROTECTED]">news:91n57o$24g$[EMAIL PROTECTED]...
> Hi all,
>
> I'm trying to configure a 2501. There's nothing in the flash. I configured
> the E0 with an IP and connected it to a laptop. I'm trying to upload the
IOS
> but the interface keeps going up and down :
>
>
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> up
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> down
>
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> up
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> down
>
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> up
> %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed state
to
> dow
>
> The prompt I'm at is : Lab_D(boot)#
>
> Any ideas ?
>
> Thanks,
>
> Bharat
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
