I am pretty sure you'll have to figure out what should be configured to
specify the logical channels coming from the x.25 node. For our network we
only specify the "htc" . This can be lic, hic, ltc, htc, loc, hoc.
i - incoming
t - two-way
o - outgoing
l - low
h - high
c - circuit
Oh, wait a minute in the book it says for a pvc you use x25 pvc ## instead
of like what we use x25 htc ##. I've never done an x.25 pvc before we always
do SVC's.
(This should match the amount of logical ports configured on the x.25
node. If it doesn't it won't not work most of the time it will most of the
time hang the ports on the node if say you configure more channels on the
router than are set on the node for your spoke.)
The way we normally configure this is with a translate statement, but the
way we do it is far from normal. You can try using a translate statement it
will probobaly work, but the proper way to configure a PVC is to use the x25
pvc <virtual channel number><protocol to translate to such as ip><protocol
address of the host at the other side><x.121 address><options such as
broadcast>
I would just additionally verify the packet size and window size you have
configured.
>>>Brian
>From: "kw.wong(Ah Wang)^_^" <[EMAIL PROTECTED]>
>Reply-To: "kw.wong(Ah Wang)^_^" <[EMAIL PROTECTED]>
>To: [EMAIL PROTECTED]
>CC: voyie wu <[EMAIL PROTECTED]>, terence <[EMAIL PROTECTED]>,
>"patrick.lo" <[EMAIL PROTECTED]>, rayyau <[EMAIL PROTECTED]>,
>"raymond.yeung" <[EMAIL PROTECTED]>, "danny.leong"
><[EMAIL PROTECTED]>, charlesw <[EMAIL PROTECTED]>,
>Cheng Man wai <[EMAIL PROTECTED]>, vincent
><[EMAIL PROTECTED]>
>Subject: x.25 connection problem
>Date: Thu, 28 Dec 2000 00:30:41 +0800
>
>Dear All :
>
>I went connect to our company cisco 2610 through the lease line to x.25
>system in B company. But, B the company hotline operator said : no any
>config in our 2610 router. Just create the PVC circuit only and ignore
>the pvc circuit number.
>
>1 ) How to config the serial interface connect to X.25 system.
> This information provide from this B company.
> interface Serial0/0
> no ip address
> encapsulation x25
> x25 win 7
> x25 wout 7
> x25 ips 1024
> x25 ops 1024
> lapb T1 3
> lapb N2 10
>
>2 ) I know the x.121 address need to apply in our router.
> But, the B company said again not need this address.
>
>3 ) how to config the PVC circuit to B company ?
> any sample config ?
>
>
>Thank you !
>
>_________________________________
>FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
>Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________________________________________
Get your FREE download of MSN Explorer at http://explorer.msn.com
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]