I think the command sequence should be:
flash_init
load_helper
dir flash:
Is this what you entered?
..dj
""C. Warren"" <[EMAIL PROTECTED]> wrote in message
92dsg9$ok3$[EMAIL PROTECTED]">news:92dsg9$ok3$[EMAIL PROTECTED]...
> Take a look at this if you haven't already.....looks like init_flash
didn't
> run properly:
>
> http://www.cisco.com/warp/public/473/36.shtml
>
> ""Kevin Hunt"" <[EMAIL PROTECTED]> wrote in message
> [EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> > I just bought a 2924XL-A off ebay and the password recovery method
> > listed on cisco's site doesn't work. I hold down the mode key, boot up
> > the switch, get the switch: prompt, type in init_flash, then
> > load_helper, then when I do a dir flash I get this message
> > "unable to stat flash/: permission denied"
> >
> > Any ideas?
> > --
> > Kevin Hunt
> > CCNA, MCSE, MCT
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
> >
>
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]