Yes you have 2 8 meg flash partitions. You could partition the flash into 1
big 16 meg chinck.
in config mode do a
partition flash 1 16
-----Original Message-----
From: ANDERSON, JEFFREY [mailto:[EMAIL PROTECTED]]
Sent: Friday, December 29, 2000 3:51 PM
To: '[EMAIL PROTECTED]'
Subject: Probably A Really Stupid 2500 Series Question
Wondering if someone could quickly answer possibly an extremely simple
question. I haven't had the time to look into this enough so any help is
greatly appreciated.
I have a couple of 2502 routers I just bought for my lab and was wondering
why the flash is configured as follows:
8192K bytes of processor board System flash partition 1 (Read ONLY)
8192K bytes of processor board System flash partition 2 (Read/Write)
I remember see something about partitioning the flash but can't fully recall
it now. The routers have 2 slots for flash and both are filled (I assume
(2) 8s). My question is can I remove both flash partition and repartition
as 16MB of Read/Write? These routers where sold as 16MB memory and 8MB
flash - is there actually 16MB of usable flash?
Again any help is sincerely appreciated.
Jeffrey M. Anderson
MCSE / MCSE+I / CCNA
SAFECO System Support Unit
[EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]