Good day, It seems that I'm stuck with a problem on my customer network. I doesn't have much idea about LANE and their existing network setup since it is managed by other vendors so the bottom line is that I cannot view their cisco router configuration at all. However base on their existing updated network schematic design, they have 4 core catalyst switches with RSM module and few distribution & floor switches. My current HP Openview and CiscoWorks configuration pointing the address of the local catalyst RSM IP with SNMP read-only enabled. I'm expecting that the HP Openview to discover all the devices in the network while the CiscoWorks discover all the routers in the network by looking on the routing table in RSM. At the end, it turns up that both of the network management software didn't discover any devices in the network even the after 2 days leaving it on my table to discover. Do you guys think that I should replicate/mirror all the other VLANs traffic into my network management port (SPAN)? Any idea or improvement should I look forward in case I left our any of requirements? Thanks in advance. p/s: I'll be appreciate that if you intend to asked a question, please reply to my email and I will reply to your query to the group again to illuminate unnecessary flooding. Best wishes, Ryan _________________________________ FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
