The message made it to the list. Because no one is really managing the
addresses on this list, whenever you send a message to the list you will
usually get a couple of bounces from bad addresses.
andy
On Mon, 8 Jan 2001, Ryan Ngai Hon Kong wrote:
> Repost.
>
> -----Original Message-----
> From: Post Master ** Do Not Use **
> [mailto:[EMAIL PROTECTED]]
> Sent: Monday, January 08, 2001 12:25 PM
> To: Ryan Ngai Hon Kong
> Subject: Mail failure
>
>
>
> [008] Failure delivering user mail due to mailbag contention.
> Mail item was not delivered to:
>
>
> ----------------------------------------------------------------------------
> --
> Microsoft Mail v3.0 (MAPI 1.0 Transport) IPM.Microsoft Mail.Note
> From: Ryan Ngai Hon Kong
> To: '[EMAIL PROTECTED]'
> Subject: CiscoWorks & HP Openview in multiple VLAN.
> Date: 2001-01-07 23:12
> Priority: 3
> Message ID: 7D8056F1D9E4D4118BB800A0C9EA57D7
>
>
>
>
> Good day,
>
> It seems that I'm stuck with a problem on my customer network. I doesn't
> have much
> idea about LANE and their existing network setup since it is managed by
> other vendors
> so the bottom line is that I cannot view their cisco router configuration at
> all.
> However base on their existing updated network schematic design, they have 4
> core
> catalyst switches with RSM module and few distribution & floor switches.
>
> My current HP Openview and CiscoWorks configuration pointing the address of
> the local
> catalyst RSM IP with SNMP read-only enabled. I'm expecting that the HP
> Openview
> to discover all the devices in the network while the CiscoWorks discover all
> the routers
> in the network by looking on the routing table in RSM.
>
> At the end, it turns up that both of the network management software didn't
> discover
> any devices in the network even the after 2 days leaving it on my table to
> discover.
> Do you guys think that I should replicate/mirror all the other VLANs traffic
> into my network
> management port (SPAN)?
>
> Any idea or improvement should I look forward in case I left our any of
> requirements?
>
> Thanks in advance.
>
> p/s: I'll be appreciate that if you intend to asked a question, please reply
> to my email and I
> will reply to your query to the group again to illuminate unnecessary
> flooding.
>
> Best wishes,
> Ryan
>
> _________________________________
> FAQ, list archives, and subscription info:
> http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
