Again, if you don't agree with the post, reply in private. No one much
cares about your personal opinion of it. The moderators of this list are
not ethics police and its not their (his) job to decide legally what
constitutes a violation of the NDA and what could even be simply made
up. Its time we trimmed this list down to technical discussion about cisco
certifications and quit trying to lead and judge each other's lives. Its
simply not that hard...
andy
On Fri, 12 Jan 2001, Joe Pinkus wrote:
> Perhaps moderators on this list will prevent a**holes who insist upon posting
>messages
> that violate the NDA
>
> Joe.
>
> Elijah Landreth wrote:
>
> > Took CCIE today. It was much easier than I expected. Not to say that there
> > is not a lot of material on the test. Here is 50 or so questions that I
> > recommend you know the answers to ;) I would love to hear about any specific
> > questions that anyone else has come across in thier written experience.
> > Would also to be curios to know the answers to questions 7, 17, 22, 23, 26,
> > 36 and 39.
> >
> > 1.What types of compression can you use over HDLC?
> > 2. Configuration registers retain settings for what?
> > 3 What is NNI?
> > 4 Best description of a hold down timer � it�s purpose?
> > 5. What is the IP multicast address range?
> > 6. What can you do to keep from having to fully mesh IBGP?
> > 7. Register is set to 0x102 what will that do?
> > 8. Whats an Ethernet jam signal?
> > 9. What is the result of sending a loop up signal to the DSU/CSU?
> > 10. When converting a serial line between to routers to X.25 what needs to
> > be done?
> > 11. LANE operates at what layer of the OSI?
> > 12. What does the gateway of last resort do?
> > 13. How would you set the gateway of last resort?
> > 14. What does setting the default gateway do?
> > 15. How do you set the default gateway?
> > 16. IPXWAN is most similar to what?
> > 17. Injecting 0.0.0.0 into OSPF AS�s causes what to happen?
> > 18. Fast Link Pulse is what?
> > 19. Fast-Ether channel has one down side what is it? (Example choices
> > given�no fault tolerance, not full duplex, no load balancing?)
> > 20. What is a proxy explorer?
> > 21. IGRP IP default network 0.0.0.0 (is this a valid route? What does it
> > do?)
> > 22. What is Erlang B?
> > 23. If a 56k line connects remote sites and there are 2000 IPX services on a
> > network where would you filter the saps at� the central router or the remote
> > router?
> > 24. How would you restrict SNMP access to a router?
> > 25. Question involving DecNet syntax to enable a designated router?
> > 26. What is meant by TCP �Slow Start�?
> > 27. Which statement best describes �Counting to Infinity�?
> > 28. What is the field type of an 802.3 frame?
> > 29. How does a router handle GNS requests from a client?
> > 30. TACACS+ has what advantages over TACACS?
> > 31. LANE�s equivalent to an ARP request is handled how?
> > 32. If TCP loses a segment during transmission how is it handled?
> > 33. What is H.323?
> > 34. When enabling OSPF the proper syntax is route OSPF ****? (Process ID or
> > AS number?)
> > 35. Administrative distances are used for what?
> > 36. If you issue the write erase command and then look into the flash and
> > the IOS is still in there with a �.d� next to it what must you do to get rid
> > of it?
> > 37. What does the �squeeze� command do?
> > 38. Question involving custom queuing in which an excerpt from a router is
> > given. The objective is to pick the statement that best describes what that
> > excerpt does.
> > 39. Question in which you are given a chart and you must select the correct
> > ACK and SEQ numbers. Chart looks like this:
> >
> > Window ACK SEQ Bytes sent HOST
> > 512 | 38177 | 90708 | 1024 | A
> > 1024 | 91732 | 38177 | 512 | B
> > 2048 | ? | ? | 1024 | A
> >
> > 40. Given a diagram of 2 routers using SRB with three hosts and asked what
> > the RIF looks like when received at a particular host. This question was
> > asked about 4 times just slightly modified each time.
> > 41. 2 questions involved comparing Distance vector to link state.
> > 42. If an Access list is applied to an outbound interface and you don�t want
> > host xxx.xxx.xxx.xxx accessing telnet services on xxx.xxx.xxx.xxx which
> > statement will satisfy the requirements of the question? (4 or 5 access list
> > syntax sensitive answers are given pick 1)
> > 43. Of the five possible answers which access list will prevent Ethernet
> > segment A from accessing token ring segment B but allow token ring segment B
> > to access Ethernet segment A?
> > 44. What is the square root 192.65.176.3 /24 divided by Pi? (Just kidding)
> > 45. There is a question involving an OSPF diagram with 3 areas, area 0 is
> > located on the far right then two more areas to it�s left what could you do
> > to fix it? (So that all areas would be able to connect to area 0)
> > 46. Know the normal reasons why a line up protocol down happens.
> > 47. What�s a LES responsible for?
> > 48. What�s a LECS responsible for?
> >
> > _________________________________________________________________
> > Get your FREE download of MSN Explorer at http://explorer.msn.com
> >
> > _________________________________
> > FAQ, list archives, and subscription info:
>http://www.groupstudy.com/list/cisco.html
> > Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
> _________________________________
> FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
