More information about your networks would help us. Can you give us a
general topology map of your PIX & routers? Also, what model PIX and
software?
--
Jason Roysdon, CCNP/CCDP, MCSE, CNA, Network+, A+
List email: [EMAIL PROTECTED]
Homepage: http://jason.artoo.net/
Cisco resources: http://r2cisco.artoo.net/
""Brian R. Keith, Sr"" <[EMAIL PROTECTED]> wrote in message
[EMAIL PROTECTED]">news:[EMAIL PROTECTED]...
> In the pix config it says I can telnet to the inside IP address from
> another IP address. Often when I do this I get:
> $ telnet (ip address)
> Trying...
> telnet: connect: A remote host did not respond within the timeout
> period.
>
> Then I get on the console.....and do a show xlate (no data appears) yet
> I do a clear xlate and then I can get onto the pix immediately. But
> if I divert my attention for a couple of minutes....I am hung and must
> hit X to get out of the telnet session and then go to the console and
> clear xlate again. If I timeout and try again I usually need to clear
> xlate again from the console. This has happened repeatedly and I am
> getting reports of other 9net addresses hanging when attempting to get
> thru the firewall also......causing their application on port 5461 to
> timeout.
>
> I do not see my attempts that fail in the log.....only those that get
> established. How can I fix this?
>
> _________________________________
> FAQ, list archives, and subscription info:
http://www.groupstudy.com/list/cisco.html
> Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]
>
_________________________________
FAQ, list archives, and subscription info: http://www.groupstudy.com/list/cisco.html
Report misconduct and Nondisclosure violations to [EMAIL PROTECTED]